Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
We noticed you are blocking ads. DO THE TON only works with community supporters. Most are active members of the site with small businesses. Please consider disabling your ad blocking tool and checking out the businesses that help keep our site up and free.
I did not forget the front hub center spacer before pressing in new bearings...but I did forget the flange spacer that slides over the center spacer. Can I get by without it?
Would love not having to drive new bearings out.
I packed the hub with grease and the spacer is aligned, axle fits fine and the wheel has been trued/tire mounted and balanced.
Looks like that "flange spacer" is what rides in the bearing and is a critical component. No cheat for this it seems, you need a stable front wheel for sure.
That can't be...the center spacer doesn't slip through the bearings, it has to go in first. And when bearings are pressed in is in direct contact with the inner races. The flange spacer fits over this center spacer and appears to be only for keeping the center spacer aligned when the axle is removed. It does not appear to me to matter where on the spacer it is position...so I'm hoping it doesn't matter if it's not there at all.
That can't be...the center spacer doesn't slip through the bearings, it has to go in first. And when bearings are pressed in is in direct contact with the inner races. The flange spacer fits over this center spacer and appears to be only for keeping the center spacer aligned when the axle is removed. It does not appear to me to matter where on the spacer it is position...so I'm hoping it doesn't matter if it's not there at all.
to be honest, I work on a farm and we always pack bearings by hand and any space that would other wise be vacant. even sealed bearings we try to work as much into them as possible. if there's grease in there, there's not water/moisture or dust/debris.
Sounds like a lot of grease, but no harm done - it should never get warm enough to expand in a meaningful way. +1 on the spacer being ok without the centering flange jobydoo. It's only function is to locate the center spacer while you slide in the axle. Usually it stays in place anyway because the center bearing races hold it there with friction. Just don't try to drive in the axle if gravity causes it to fall to the bottom of the cavity and block the axle! Probably with all that grease it will stay put!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.