Post a pic of your latest purchase
- Thread starter go!
- Start date
johngofast
Over 1,000 Posts
Nice, I'm sure you could figure a way to haul a bike in it. 
Popeye SXM
Also used for MX
K
Kamn
Guest
I have the same Lathe/Mill combo just under another name of Craftex and Grizzly has the same one. Its a decent unit when you get it all set up and adjusted
I know of 2 people out there that have made these into CNC
The nice thing about them is the amount of clearance you have around the chuck on the lathe to cut larger pieces
I know of 2 people out there that have made these into CNC
The nice thing about them is the amount of clearance you have around the chuck on the lathe to cut larger pieces
CarbsAndCylinders
Careful With That Axe Eugene
1fasgsxr said:
Looks like you are pooling a bunch of parts.
Tune-A-Fish
BOTM LOSER Proudly Deplorable
onefromexile
Been Around the Block
onefromexile
Been Around the Block
1978 Suzuki jr50 custom dragster
Sent from my iPhone using DO THE TON
Sent from my iPhone using DO THE TON
Mr.E
Got to keep the loonies on the path...
onefromexile said:
There's got to be a rad story behind this..
onefromexile
Been Around the Block
Yes it was a craigslist gem I found
Almost wasn't a bike
Frame has a vin deficiency
Was mis numbered at factory and restamped so it's either a test bike or something then the rear has a jack shaft set up and rear swing is rigid with a good year wide tire wheelie bar attachment
It was a very intersesting find that's why I snagged it
Currently running Needs a lil work on the gearing its way too low only does about 15mph because of the jackshaft setup
It's easy fix switch ratios
I'll post pics
I may just create a build thread for it
After all I bought it for my sons first bike
He's only 8mos so I got a lil time
Sent from my iPhone using DO THE TON
Almost wasn't a bike
Frame has a vin deficiency
Was mis numbered at factory and restamped so it's either a test bike or something then the rear has a jack shaft set up and rear swing is rigid with a good year wide tire wheelie bar attachment
It was a very intersesting find that's why I snagged it
Currently running Needs a lil work on the gearing its way too low only does about 15mph because of the jackshaft setup
It's easy fix switch ratios
I'll post pics
I may just create a build thread for it
After all I bought it for my sons first bike
He's only 8mos so I got a lil time
Sent from my iPhone using DO THE TON
onefromexile
Been Around the Block
Vin is 000-000-xxxx
Re stamped 100-000-something
I think
I'll have to look again
Sent from my iPhone using DO THE TON
Re stamped 100-000-something
I think
I'll have to look again
Sent from my iPhone using DO THE TON
Scooter trash
Been Around the Block
A new 44t sprocket, sprocket damper, sprocket wheel bearing, wheel spacers. At first, the axle appeared to be too loose, closer inspection a wheel bearing failed that allowed the chain to climb over the sprocket. At least it was on the dyno when it happened. Bike is pushing over 300hp now so this is all part of the "Fail Trail". Next up ???, a crank, rod, piston, tranny, who knows.
