K
Kamn
Guest
Looks like you can make your own clutch holding tool with some welding vise grips, heat, and a hammer
adventurco said:I actually have read through there. The formatting on that forum makes it a pain in the ass to read though. I guess a popular mod on the FA50 is to shave the mating surface of the head, I think you can take about 1mm off to make the fins sit even with the cylinder. I'm not set up for it, all I have is a belt sander
Sent from my iPhone using DO THE TON
DesmoBro said:It will probably run with 60
teazer said:nice work on that rewind. Must be satisfying to see blue sparks after all that effort. Timing is probably in the 20-24 degree BTDC range. If it has points ( I can't remember) it's a PIA to time because you have to remove the flywheel to set/adjust them or to move the backing plate and then bolt it back on to test and repeat until you get it close enough.