GL1100 Acewell 4xxx wiring.

Looking for help I have an 80 gl1100 win the 4xxxx acewell unit. It's time to wire the sucker. Anyone do this before who can help? Maybe it's the same for a cx500, cx650, gl500/650. Thanks!
I hope you can help!


Sent from my iPhone using DO THE TON

If you have a wiring diagram for your bike it really isn't that hard. The Acewell comes with a wiring schematic.

hillsy said:

If you have a wiring diagram for your bike it really isn't that hard. The Acewell comes with a wiring schematic.

Click to expand...

I do, however maybe it's just a little overwhelming at this point ha it's been a long winter with various frustrations. Any help would be appreciative.


Sent from my iPhone using DO THE TON

I just installed an acewell 2853 on my XV1100 and can say that it is not to bad to install.

Just break it down into sections.
Do your power, So constant, switched and earth.
Then do your indicators. Left, right and hazard.
Then do oil pressure and fuel
ect ect

If you do it that way it is quite a bit easier.