Filling holes in frame

Ride

Active Member
9525f90ef3f89f46c088ebf0306a6cc3.jpg


How would I go about filling these 2 5/16” holes?

JB Weld?
Epoxy?
Straight up bondo?

And I’m guessing I have to dimple the hole to give a little more surface area and be able to sand flush?

The larger opening needs to be left open to access the shock mount.

Thanks for any advice!
 
Weld them shut would be the best way to go if that's something you could do. If not I'd bet a local muffler shop would squirt a little goo metal in there for a few bucks

Sent from my SM-G920V using Tapatalk
 
HURCO550 said:
Weld them shut would be the best way to go if that's something you could do. If not I'd bet a local muffler shop would squirt a little goo metal in there for a few bucks

Sent from my SM-G920V using Tapatalk
Goo metal?
 
Back
Top Bottom