75 CL360 Cafe Build

[MrMister]

Nice work. I ran a cable on mine, which I've found to work pretty well but may have been a bit of extra work involved.

You may find your rear brake will perform better if the cams are parallel to each other:

Yeah, these sets are a bit limiting on giving you flexibility for positions. Its all in 90 degree increments.

[MrMister]

New heavy duty clutch springs are a bit longer than stock. Oiling mods for the oil filter exit passage. Holes in the clutch basket to help keep it cool.
And had to replace my brand new Pirelli demon because it was cracking on the sides.

[MiniatureNinja]

cool stuff. Dig that color scheme

one word of advice on those old school speed rearsets (I had them before I went back to stock) get some rod ends from QS components and replace those crapy 90* ends. they will kill you at worst and make adjustments and pedal feel terrible at best.

[MrMister]

cool stuff. Dig that color scheme

one word of advice on those old school speed rearsets (I had them before I went back to stock) get some rod ends from QS components and replace those crapy 90* ends. they will kill you at worst and make adjustments and pedal feel terrible at best.

Thanks for the tip. Absolutely will do.


Sent from my iPhone using DO THE TON

[MrMister]

Got new rod supports as recommended by @miniatureninja from qs components.


Sent from my iPhone using DO THE TON

[MrMister]

Also got new YSS rear shocks.


Sent from my iPhone using DO THE TON

[MiniatureNinja]

Got new rod supports as recommended by @miniatureninja from qs components.


Sent from my iPhone using DO THE TON

sure does make it nice doesnt it? big improvement over what comes in the kit