collapse

www.dimecitycycles.com


www.restocycle.com

www.CITYLIMITMOTO.com

www.jadusmotorcycleparts.com

www.bisonmotorsports.com

www.speedmotoco.com

www.lostapostlejewelry.com

www.cognitomoto.com

www.townmoto.com

www.sparckmoto.com

www.Moto-Madness.com

www.pistonsociety.com

www.steeltowngarage.com

OUR ADS ARE FROM SUPPORTERS OF THE COMMUNITY - CONSIDER TURNING YOUR AD-BLOCKER OFF FOR WWW.DOTHETON.COM

Author Topic: Long awaited CB200 Build  (Read 16012 times)

Offline Alex jb

  • Posts: 320
Long awaited CB200 Build
« Reply #130 on: Jun 04, 2018, 18:15:58 »
The bores inside (with the oil groove) are the bearing surface for the cam, hope they didnít get too bead blasted.
« Last Edit: Jun 07, 2018, 10:22:27 by Alex jb »

Offline bex

  • Posts: 105
Re: Long awaited CB200 Build
« Reply #131 on: Jun 05, 2018, 07:52:42 »
Donít worry!

Offline Pete12

  • Posts: 180
Re: Long awaited CB200 Build
« Reply #132 on: Jun 05, 2018, 20:03:56 »
Make sure they are really clean, particularly the oilways. That glass bead gets in everywhere and, well you know how hard glass is....

Offline bex

  • Posts: 105
Long awaited CB200 Build
« Reply #133 on: Jun 06, 2018, 02:27:07 »
Thanks - will do. I get stuff vapour blasted. Itís a finer finish. Although you still get metal dust and potentially some leftover over media which needs a good clean up as you say.
« Last Edit: Jun 06, 2018, 02:36:54 by bex »

Offline bex

  • Posts: 105
Re: Long awaited CB200 Build
« Reply #134 on: Jun 18, 2018, 07:30:22 »

Offline Alex jb

  • Posts: 320
Re: Long awaited CB200 Build
« Reply #135 on: Jun 18, 2018, 15:22:52 »
Swanky photo!

Looks more than ready to be in that frame