We have rims and spokes on order
Hubs will be sent away for polishing soon too, then will be getting it all together with some sticky rubber in early September. We are not far from a rolling chassis, only taken me since Mar to get wheels on it.
Flogging some excess bits on eBay too so hope to have an order in for clip ons too over the next day or so. Looking at these bad boys which I assume fit over the GSXR forks at the top near the triple clamp:
http://bit.ly/Prfiou
Also plan on making some headlight ears too using SS hose clamps and 3mm Alu I've got lying around. Fingers crossed it doesn't look like shit
Sent my caliper carrier off to be made into 2 this week in 8mm steel. Should have them back in a week or so too, then I need to revisit the calipers as I didn't paint them wet enough. Strip and paint or just lay another coat over the top?
Slowly getting there. As my mum used to say "slowly, slowly, catchy monkee".
Not much left to buy
Tyres
Headlight bucket and lens
Front brake lever/mc and clutch perch
Front braided brake lines
Grips
Swingarm brace and rear shock mount steel
Shock
Brake light
Carb rebuild
Paint frame
Swingarm bushes (bronze)
Drive train
TTR400 rear-sets
SS tube for indicator stalks
Paint tins and frame
Oh and then the motor:
466 pistons (and boring)
New gaskets
Cam chain
TTR400 cam chain tensioner U
Cam chain sliders
Cam fixed and journal
Primary chain
Elec ignition
Coils
Crank bearings
Then BOOM! Ready to ride and look farkin cool