Ok peeps it's been a while but I'm finally getting back to working on the T500. I never did get it running properly so I am going to go through the engine again. I am going to rebore it while I'm at it as I never did get it done when I rebuilt it. I have the new pistons so I might as well do it. Big question is where to get it bored. There are no shops local to me here in SoCal that I know of so I am looking at Millenium to do it for me. However it is $165 per cylinder Seems a bit steep to me but is that the going rate? If any of you have other suggestions I'm listening ;D