Just doing some research before I destroy the frame on my project CB750. I've seen in a few online videos and the like (Cafe Racer's episode of DCC most notable) that some kind of blow torch was used to detab some bike frames.
I'm going to have a number of tabs and centre stand to remove from my bike. And I'm not wondering if this is the preferred method by these workshops for any reason in particular. I've only got a Grinder available in my own workshop, are there any downsides to using this?
I'm going to have a number of tabs and centre stand to remove from my bike. And I'm not wondering if this is the preferred method by these workshops for any reason in particular. I've only got a Grinder available in my own workshop, are there any downsides to using this?