Bimota HB1 Honda CB750 Clone

Fitting the seat
 

Attachments

  • image.jpeg
    image.jpeg
    1.2 MB · Views: 422
This thing is on another level! Awesome work man. Thanks for sharing it here
 
Really nice carbon work, the weave is consistent even along the tight bends where most people get a lot of distortion. Nice!
 
Got ledt side exhaust fitted. Still need trimming and weld up.
 

Attachments

  • image.jpeg
    image.jpeg
    1.5 MB · Views: 345
Not often does the word "perfect" pop into my head in regards to custom bikes... It does now though.
 
Exhaust about 80% now. Brackets, welding and detailing to go.
 

Attachments

  • image.jpeg
    image.jpeg
    1.7 MB · Views: 402
Is it possible to bring the two lower pipes in a little to give it a V look from the rear. It would also add some cornering clearance too.
 
teazer said:
Is it possible to bring the two lower pipes in a little to give it a V look from the rear. It would also add some cornering clearance too.
They are about 1/2" to 1" away from swing arm now.
Vertical is more iconic for this bike but it can be done.
I can do it that way if you like. I just need a $5000 deposit. LOL
 
Made battery/solenoid tray and aluminum hangers for exhaust.
 

Attachments

  • image.jpeg
    image.jpeg
    926.3 KB · Views: 355
  • image.jpeg
    image.jpeg
    1.2 MB · Views: 364
  • image.jpeg
    image.jpeg
    974.8 KB · Views: 362
Made new starter cover to mount solid state regulator
Tearing down for paint next week after fitting new custom
oil tank.
 

Attachments

  • image.jpeg
    image.jpeg
    1.5 MB · Views: 347
  • image.jpeg
    image.jpeg
    1.1 MB · Views: 343
  • image.jpeg
    image.jpeg
    2 MB · Views: 356
Back
Top Bottom