After a long hiatus I tore back into my CB360 project. I pulled the bottom case to replace the kickstart shaft and I'm in the shop now ready to go back together. I've never been into a motorcycle case before. I have hondabond. Do I put a thin layer on both sides before I put it together? There was hondabond Also in the case groves of each bearing half. How do I get it in there? I also put new seals in. No hondabond there correct?
Sent from my SAMSUNG-SM-G891A using Tapatalk
Sent from my SAMSUNG-SM-G891A using Tapatalk