Finnigan
Over 1,000 Posts
Pulled the engine on my cb450 after the oil started seeping from the cylinders somewhere. Found out it was from the base of the cylinders/engine case, the oil was soaking through the gasket from each cylinder equally. used a scraper to get the remaining gasket and found there were no burrs on either side of the mating surface. Not going to take it to a machine shop to get it perfectly flat.
So, can I put honda bond on each side of the new gasket to stop this from happening again?
So, can I put honda bond on each side of the new gasket to stop this from happening again?