irk miller said:Adamantium
doc_rot said:I need to bore this needle bearing inner race from 16 to 17mm. A carbide boring bar wouldn't cut it at all. I'm thinking about making a tool holder for a dremel and putting a sanding drum on it. what should i do?
Poor mans tool post grinder. Well done.Pete12 said:I made a tool post holder for a die grinder with a cylindrical stone to grind my chuck jaws. I angled it very slightly to cut on the leading edge and it worked perfectly.
J-Rod10 said:Poor mans tool post grinder. Well done.
*Not calling you poor, just far cheaper than a tool post grinder.
Pete12 said:I made a tool post holder for a die grinder with a cylindrical stone to grind my chuck jaws. I angled it very slightly to cut on the leading edge and it worked perfectly.
c.h.stoltz.1 said:Hi guys I have a Suzuki GSX1100 RR I have redone the wiring but it looks like I missed something. I have electrical power ( constant 12v ) up to the coil packs but no spark. I have changed the cdi and everything exept the signal generator and the coil packs. Do any body know what can be the problem ?
Sent from my SM-G935F using Tapatalk
Everyone should have a flex shaft anyway. They fit conveniently in a holder, or get the right size boring bar holder...doc_rot said:The problem I ran into is as the cut progresses the grinding stone wore down producing a slight taper in the bore. It was a little tricky but I got a pretty good fit. If I was going to do this more frequently I would make something like this https://m.ebay.com/itm/The-ORIGINAL-Dremel-tool-holder-frame-metal-lathe-1-2-in-sq-shank-/361520655374?nav=SEARCH
irk miller said:Everyone should have a flex shaft anyway. They fit conveniently in a holder, or get the right size boring bar holder...
Sent from my iPhone using DO THE TON