Need a CB 360 camshaft! Ready to buy

Stayradmoto

Stayradmoto

Active Member
Hey anyone out there have a CB360 camshaft in decent condition? I just cracked mine tightening down the points cam. So dumb. Telling myself that it mush have had a small crack in it because there is no way I righted that hard. Who knows. Aaaaaaah. Any help appreciated!
 

Attachments

  • C5894C8F-0BDF-49CA-8BB1-2125D99054E4.jpeg
    C5894C8F-0BDF-49CA-8BB1-2125D99054E4.jpeg
    1.4 MB · Views: 183
Welcome to DTT.

If no one here has one laying around...Theres one in Germany, United Kingdom and Netherlands.

https://www.ebay.com/itm/Honda-CB250-G-CB360-74-76-Nockenwelle-camshaft-assembly-G5-CB360T-CL360/152782213615?hash=item23928791ef:g:VbwAAOSwC~FaBcMN

https://www.davidsilverspares.co.uk/CB360T0-1975-USA/part_274454/

CMSNL has lost their minds. LOL

https://www.cmsnl.com/honda-cb360t-1976-usa_model439/camshaft_14101369000/#.WwvOEi_MzBI
 
Nice thank you! I couldn’t find those. Looks like the second one is in a us warehouse. I think I’ll wait until the end of the day and see if any show up. If not I’ll order that one. Thanks again!
 
That's unusual for a camshaft to crack. Are you sure it's a crack and not just a casting line?
 
Ya this is embarrassing to admit but I cracked it tightening down the points cam. So stupid. In my defense it didn’t take much at all to crack. Prob a half turn over contact. Every other bolt on engine was meticulously torqued to spec and i lost my mind on this one.
 
If the crack is contained to the end of the shaft, it may be possible to braze it together - if it broke off completely that may be more difficult.
 
Ya it just broke off today taking the points off. In better news I found one on eBay from a guy who was selling a whole engine. I messaged everyone with a full engine and he took me up on my offer. Sending it across the country tomorrow.
 
teazer said:
If the crack is contained to the end of the shaft, it may be possible to braze it together - if it broke off completely that may be more difficult.
Click to expand...
I've repaired one by bolting broken off piece back on. Not too much extra work as I 'gun drilled' it for oil flow and used an Allen bolt from right side. It's only an experiment and may need a small section o-ring under points cam as I don't know how well ''Loctite' will seal the 'crack'? The alternative would be to make a new extension of larger diameter with flange and screw/pin it in place but I thought I would try the easy way first
 
You must log in or register to reply here.

DTT Light or Dark

  • DTT Light
    • www.jadusmotorcycleparts.com
    www.lostapostle.ca/
    www.sparckmoto.com

    Spread the Love

    Back
    Top Bottom