CB 360, Can you identify this part?

A

Andy.1272

New Member

• Jun 30, 2018

• #1

I was recently working on my 76’ CB 360t. As I was removing the motor (rocking it out of the frame) this piece fell from the bike. I have no idea where it goes, please help. I’m thinking it has to go with the mounting of the motor or the rear brake pedal...? It appears to be a heavy spacer or washer.

 

Attachments

• 
  1B1B53D7-5FBB-4E80-8C7D-2153A54CD088.jpeg

  1.7 MB · Views: 197
• 
  1369ECF7-20E4-4329-92C6-4AD647C00E12.jpeg

  1.8 MB · Views: 190

trek97

No Custom Title

DTT BOTM WINNER

• Jun 30, 2018

• #2

That one gets guys al the time.
Its a spacer that was on one of the engine mount bolts.
You can find it on microfiche.

 

trek97

No Custom Title

DTT BOTM WINNER

• Jun 30, 2018

• #3

Haha often enough I already had the fiche in my gallery...#3

 

A

Andy.1272

New Member

• Jul 1, 2018

• #4

Yes! That's the one. Thank you so much!

 

irk miller

You've been mostly-dead all day.

DTT BOTM WINNER

• Jul 1, 2018

• #5

Ha. That one got the PO of my current 360, too. I had to machine a replacement.

 

crazypj

Split personality, I fake being smart

• Jul 1, 2018

• #6

Yep, I think a few people here had rear lower engine plate cracked or even broken when that bit got left out then bolt wound down. It's surprisingly heavy for such a small part, I swapped all mine to 6061 alloy as it's only a 10mm hole through a bit of bar then face to length

 

MiniatureNinja

Coast to Coast

DTT BOTM WINNER

• Jul 1, 2018

• #7

crazypj said:

Yep, I think a few people here had rear lower engine plate cracked or even broken when that bit got left out then bolt wound down. It's surprisingly heavy for such a small part, I swapped all mine to 6061 alloy as it's only a 10mm hole through a bit of bar then face to length

Click to expand...

if I had a lathe I would make one - but I went ahead and got a TTR400 spacer kit - $50 not a bad deal