Change of mind. 77 kz650

Attachments

  • 1469235859791.jpg
    1469235859791.jpg
    38.4 KB · Views: 300
  • 1469235869211.jpg
    1469235869211.jpg
    29.8 KB · Views: 303
I'm not going t9 take the ginder to them either when I detab the frame they kids match the factory welds. I actually found a piece of mig wire on the swingarm forgotten by kawasaki

Sent from my SM-G900W8 using DO THE TON mobile app
 
Have you welded the swingarm pivot to the frame? If not, you should because over time when the bearings wear / collapse you will have movement there and it will eventually break the rear hardtail somewhere.


If it was me I have taken out the swingarm and just welded in a conventional style hardtail.
 
Got the tanks dents fixed and the area where the tags were, filled in.

Sent from my SM-G900W8 using DO THE TON mobile app
 

Attachments

  • 1472954062549.jpg
    1472954062549.jpg
    49.6 KB · Views: 276
  • 1472954072788.jpg
    1472954072788.jpg
    67.8 KB · Views: 282

Attachments

  • 1473566912238.jpg
    1473566912238.jpg
    43.1 KB · Views: 898
  • 1473566901660.jpg
    1473566901660.jpg
    43.6 KB · Views: 961
  • 1473566890847.jpg
    1473566890847.jpg
    43.8 KB · Views: 287
  • 1473566872129.jpg
    1473566872129.jpg
    58.6 KB · Views: 822
Got the front end together again to get a look. Haven't repacked the bearings yet. Will do that after the frame has been finished. Tanks still needs some work but it think it's looking pretty good.

Sent from my SM-G900W8 using DO THE TON mobile app
 

Attachments

  • 1473645104241.jpg
    1473645104241.jpg
    60.6 KB · Views: 291
  • 1473645094330.jpg
    1473645094330.jpg
    56.5 KB · Views: 287
  • 1473645083700.jpg
    1473645083700.jpg
    68.7 KB · Views: 301
  • 1473645074950.jpg
    1473645074950.jpg
    60.9 KB · Views: 825
  • 1473645066953.jpg
    1473645066953.jpg
    49.2 KB · Views: 886
Got the rear hoop.and supports in all sleeved 2 and a half inches rear plastic is just resting there. Have the shock mounts to weld on then remove tabs and get her painted. got brand new rings and made my own gaskets. So engine is going to be cleaned and put back together

Sent from my SM-G900W8 using DO THE TON mobile app
 

Attachments

  • 1475282697228.jpg
    1475282697228.jpg
    64.7 KB · Views: 277
  • 1475282712032.jpg
    1475282712032.jpg
    54.7 KB · Views: 289
  • 1475282726672.jpg
    1475282726672.jpg
    57.2 KB · Views: 287
Getting the seat pan templates made and the stash spot for the electrical components

Sent from my SM-G900W8 using DO THE TON mobile app
 

Attachments

  • 1476771832756.jpg
    1476771832756.jpg
    52.2 KB · Views: 272
  • 1476771842114.jpg
    1476771842114.jpg
    50.6 KB · Views: 270
Back
Top Bottom