Velocity stack cover

cafechris

Been Around the Block
Looking for a set of velocity stack covers like were used on the slingshot dragsters, all four 'balls' connected via string.
Any leads are greatly appreciated!

CH
 

Attachments

  • 1479999560222.jpg
    1479999560222.jpg
    52.4 KB · Views: 224
they weren't just balls,nope dude ::) ::)tennis raquet hand whichever ball fits,its the design fab work
o\k then you got hire somebody to put the rocket science like project to fruition there is tha catch pall
gonna need to 3d model the design in capcad app,probaly water jet print some potato-types for testing
dont breathe the poisin gasses that comes outta the balls ,punching holes to fasten the tether line anchor line mounts,deals ,fully purge in well venti......
 
That is hilarious. I know racquet balls have been used, drilling a hole, and passing a rope/chain through but was hoping for a real set.

CH
 
http://www.jackwatsonsports.com/Tri_Coloured_Sponge_Ball_p/p33.htm. Close but not quite correct size

CH
 
if you have a hydraulic service supply store nearby they always have a selection of plastic caps/plugs for hyd fittings and hoses
the tapered series is the type i refer to
http://www.capsnplugs.com/hydraulics/c/831
 
didthetonatten said:
That may work. Thanks xb.

CH
yup it would cool to have 2 sets one smaller that stuff into the stack for to better show off the stacks and a second set to go over the bell mouths for warshing and really secure protection
 
Back
Top Bottom