Blano
New Member
Hello, new to the forum and still trying to work my way round it but there seems like plenty of info. I’ve bought myself a cb650z which ran a bit rough which it turns out was from being dropped on its side and causing irreparable damage to the No1 carb. Managed to get hold of some Cb750 carbs and got some fluoro linedsilicone tubing to use as the inlet rubbers. I’m thinking matt black with some brown cafe racer/brat mix. Already cut the frame and put on a seat loop I managed to make fit the seat I ordered just got to have a go at continuing the support bracket from the frame onto the seat loop (first time welder) then tick away at everything else. any hints/tips are welcome
Sent from my iPhone using DO THE TON
Sent from my iPhone using DO THE TON