Trx850 cafe
- Thread starter deepwaterimports
- Start date
deepwaterimports
Over 1,000 Posts
Setting up positions
deepwaterimports
Over 1,000 Posts
New headlight has arrived.
Thinking of mounting outside faring like this:
Thinking of mounting outside faring like this:
deepwaterimports
Over 1,000 Posts
Bike awaiting the chop.
Worked out mount location where to fab and what to lose. Updates soon
Worked out mount location where to fab and what to lose. Updates soon
deepwaterimports
Over 1,000 Posts
Thanks guys, that's exactly what I was thinking rundown and I want something reliable and consistent. Style and safety.
deepwaterimports
Over 1,000 Posts
Rear end chop. Seat was widened to look neater / in proportion and for comfort.
deepwaterimports
Over 1,000 Posts
Tossing up where to mount the rear lights what do you think 1, 2 or 3.
1.
2.
3.
1.
2.
3.
deepwaterimports
Over 1,000 Posts
Cheers guys. I am liking 3 too but there have been lots of builds with that same design which pushes me to option 2. My headlight is going to be mounted off to the side so I think the rear may be too much in option 1.
deepwaterimports
Over 1,000 Posts
Some more updates :
- fibreglassing mostly done on the seat.
-seat mounts nearly all done.
- front fairing mounts getting fabed cut all the waisted tabs etc.
- fibreglassing mostly done on the seat.
-seat mounts nearly all done.
- front fairing mounts getting fabed cut all the waisted tabs etc.
Beqautiful bike. Two things, if you were to raise the angle of the mufflers slightly and then trim the underside of the eat slightly they could be parallel. The bottom line of the tank and seat still need some tweaking, I can't see an easy solution, but others probably can.
deepwaterimports
Over 1,000 Posts
At the moment rundown the pipes are staying but in a few months I'm looking to do a two into four system with shorty reverse cones.
Cheers bigsherm
Cheers bigsherm
deepwaterimports
Over 1,000 Posts
Headlight fitted and looking sharp.
