Re dishing wheel

Erskine

Over 1,000 Posts
I need to move a rim 1/4" to one side ....
Should I
A) loosen off all one side then tighten the other
Or
B) loosen off one spoke then tighten the opposite ?
 
No Honda that I know of came with an offset rim to the hub. I would find out why your wheel is not centered, spacer issue?
Is the rim and hub not centered now and you need to center it? If so, yes, loosening one side and tightening the other is correct. If this is the case, is this new lacing or a stock wheel?
 
It's a rear MZ wheel being used up front. I've done it now, was quite easy to do, loosened one side, tightened the other.
 
Back
Top Bottom