Suzuki GT550

84bea109c60bc7e53661bae6b7ebc297.jpg
seat mocked up with integrated tail, brake, and turn signals


Sent from my iPhone using DO THE TON
 
JEMCO pipes. Nice.

Much nicer that the set I'm welding up right now. Jon Easton does nice work.
 
I did notice that. As a rule, Jemco pipes fit pretty well out of the box. The thing that can be annoying is the way that the tailpipes/silencers are not parallel on the right side. Getting the two mufflers parallel would be a huge improvement in looks IMHO.

With that SV swingarm, it may be necessary to route them slightly differently and the weld on tail pipe and removable mufflers may make that easier.
 
teazer said:
I did notice that. As a rule, Jemco pipes fit pretty well out of the box. The thing that can be annoying is the way that the tailpipes/silencers are not parallel on the right side. Getting the two mufflers parallel would be a huge improvement in looks IMHO.

With that SV swingarm, it may be necessary to route them slightly differently and the weld on tail pipe and removable mufflers may make that easier.
0326a02ca024c4b82bff0f2ef0a267b8.jpg
that's the plan for the stringers on the end to be some what even and parallel



Sent from my iPhone using DO THE TON
 
CrabsAndCylinders said:
That swingarm looks very long but it also looks like it would be easy to shorten it.
We thought about it, we could move the wheel forward about and inch before it hits the swing arm pivot


Sent from my iPhone using DO THE TON
 
Also we ended up lowering it 1.5 inches, the last picture is the before picture


Sent from my iPhone using DO THE TON
 
Back
Top Bottom