Carb part needed

Hey guys,
I need a float bowl for my 76 cb750 as one of the drain tube is broken.

Cheers


Sent from my iPhone using Tapatalk

You can try fixing it.

Chisel any remaining tube level with the aluminum.

Drill it out with a #25 drill bit.

Get a length of 5/32 OD brass tube. (Available from hobby shops and some hardware stores.) Make it 1/2" or so longer than needed. Heat the tip with a torch to anneal. Peen the tip to a smaller opening.

cut to the required length, and press into the hole you drilled out.

Thanks for the tip...if I can’t find one, I’ll end up doing that


Sent from my iPhone using Tapatalk