JustinLonghorn said:Riding on a dolphin, doing flips and shit.
https://www.youtube.com/watch?v=R7yfISlGLNU
JustinLonghorn said:Riding on a dolphin, doing flips and shit.
Mr.E said:I'll pull up a chair and watch this'n too
The EX bolts are 6mm longer than they need to be, but the shoulder is for the the EX disc not the center so it fits fine. I cut 6mm off the bolts and I'll run a nut on the inside of the 360 center. I'm not sure why you did the spacer, either. Did you run a front end that needed an offset?crazypj said:I can't remember why but I had to make a 6mm thick spacer to fit Kawasaki EX500 rotor to Honda centre?
deviant said:
Are you rubbing it in? LOLMr.E said:It doesn't look very cushy right now tho
deviant said:Are you rubbing it in? LOL
Mr.E said:Ha, nope. I don't think I knew about your lathe breaking at that time.
No cogs. I might be screwing up the terminology. If it does need a mill, I'll send it upstate.Tune-A-Fish said:Won't you need to mill the cogs? does the brake side have a cushy