Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
We noticed you are blocking ads. DO THE TON only works with community supporters. Most are active members of the site with small businesses. Please consider disabling your ad blocking tool and checking out the businesses that help keep our site up and free.
So I'm nearly done with the head work
It's been quite the task matching the intakes to within a thousandth
The exhaust side got extensive work and the chambers and exhaust port are smooth and clean like mirrors and matched to within a thou also
I'll be going with the 378cc
Upgrade so once completed I'd like to see some solid numbers I may pay to have head flow tested
If I can find stock numbers
Im positive in a significant improvement over stock
And yes I had a hard time trying to port match intake side without taking away
As it's been researched 360's already have a great if not overkill amount of intake flow
But with the new displacement from gs850 Pistons in the plan
Any minute amount of metal I removed from intake side cleaning up casting marks and port matching shouldn't negatively affect performance
In process of developing
Oil cooling system
Tcs micro pumps
Runs about 1-7watts (controlled)
Pushes just under a liter of fluid at a constant 6psi
Should be bolt on system application except valve cover
I'll try to post a few pictures of the design drawings
It will utilize starter nose cone and end cone thinking plexi tube in between cones inside will house micropump and controller
Lines in/out to from engine
Small oil cooler etc.
With upgraded charging system and led lighting conversion
There is enough watts to spare 1-5 for my oil system
Depending on rpms
I'm using a stainless steel hinge cut and bolted to under lip of tank yes the hinge will be removable from tank and the hinge pin
The rear will be locked down with Zeus fasteners
On the side the underside has clearance for electronics
And gets air for keeping cool
Lots of shitty welds
Lots of grinding
Since picked up a new welder
Just couldn't do it without gas
It was struggling to fuse 18 gauge to frame
Without.burning through sheet
Lower setting wouldn't fuse to frame ugh
Anyhow will update frame pics after the finish welds and prep and primer
Undecided on blackmatte or matte charcoal metallic
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.