Seat pan and hoop both looking great!TXBenelli said:Seat pan round 2, this one with a much larger radius bend to match the new tail section bends.
Sent from my iPhone using DO THE TON
Seat pan is 3/16" thick. I think the foam glued to the steel and essentially a cover that slides over the seat pan and foam and laces on the bottom side. Just a thought currently.flamelspy said:Seat pan and hoop both looking great!
What is the thickness of the seat pan?
Isn't it too thick? And how you intend to fix the upholstery to it?
These questions I ask myself in my current project, looking for others viable solutions than i have already thought about haha
Yeah I'm having to take a break from the bike because of work but I hope to get back on it soon. Where my job is taking me daily has an upholsterer that has done work for me before I'm going to take it to them after I get done mounting the seat pan. It's just sitting there on the frame.NoRiders said:I had thoughts of a seat material retaining clip system for my seat, which I built myself, but had pro upholstered. They used high quality glue and two pop rivets (on a fold) to hold it down, no problems.
Bike's coming together well fella.
TXBenelli said:Yeah I'm having to take a break from the bike because of work but I hope to get back on it soon. Where my job is taking me daily has an upholsterer that has done work for me before I'm going to take it to them after I get done mounting the seat pan. It's just sitting there on the frame.
Thank you I think it's gone through a lot of changes from my first ideas but getting closer to what I had in mind big picture wise.
Sent from my iPhone using DO THE TON