Rolling tank seams

2_DONE_THE_TON

Over 1,000 Posts
DTT BOTM WINNER
Hey guys!

I ran into this little tank i would like to fit on my new XS 750 project.
Is it possible to roll the welding seams of that gas tank over without it leaking?
How would you guys go about?
85ea7d72308fd639354bd86dad4cbed4.jpg
9bf1b118c3bf34dc7cabfa82508921aa.jpg


Sent from my SM-A310F using DO THE TON mobile app
 
If it were me, I would use an adjustable wrench clamped over the seam and inch by inch bend it inward.

Possible without leaks? Probably not, but just weld up any little leaks afterwards.
 
Back
Top Bottom