cbrianroll
Coast to Coast
Yup....lowered bars now my brake lever won't rotate down. Looking for a decent priced replacement. Never shopped for one before so kinda lost on what to look for....thanks
kz550ltd master cylinder
- Thread starter cbrianroll
- Start date
TheCoffeeGuy
Books, Books, Books, knowledge is within
There is a pin on the inside of the brake part that goes around the handlebar. Loosen it right off, find the angle that fits your stance, then drill another alignment hole in the handle bar.
cbrianroll
Coast to Coast
Sorry for my bad explanation.....they spin on the bar, but the edge of the m.c. hits the fork tube at a very high angle.
TheCoffeeGuy
Books, Books, Books, knowledge is within
So most metric bike use a 10 MM banjo bolt. Pretty much any MC will work that has this connection. I would stay with ones for single discs if you have a single disc, or one for double discs if you have a double disc.
cbrianroll
Coast to Coast
Thanks much!
