So I finally tried this stuff today for the first time today, it sure is messy!
One thing I couldn't get the hang of was getting a consistent amount of Stuff out of the nozzle to make a good even line. And, things got super messy when I tried to circle around bolt holes.
I used it to seal my valve cover after checking tappet clearance. I'm a little sketched out by the thought of the run off (lack of a better way to say that) coming off inside the valve cover, whats it do when it gets in my valves? ???
We'll see how my messy first attempt holds out when I run the bike for more than ten minutes.