Did I buy junk?

doc_rot said:
I recently bought these used hard welded and reground cams for a kz750 sight unseen. When they showed up the bearing surfaces and cam lobes were covered in a waxy grease. After removing this I am dismayed to find there is substantial rust and pitting on the bearing surfaces and the base of the cam lobe. Are these trash?
Pretty much


Sent from my XT1254 using Tapatalk
 
crazypj said:
Place up in north west, Seattle area. I forget name but e has advertised a few times
I think rocker repair was about $10~$15 and cam around $100~$120
Any decent weldor can hard face cam but getting it ground back is always an issue (hell, even I tried it on Honda S65 40+ yrs ago and used bench grinder to re-profile) Doing a twin with correct separation angles would be pretty much impossible by hand though
Delta Cam in Tacoma


Sent from my XT1254 using Tapatalk
 
Back
Top Bottom