draconislivida
Nemo vir est qui mundum non reddat meliorem
First off, i thought i was "wrench literate" but this 360 is killing me. So far I've burned up two cams and three sets of rockers.
My most recent fubar, i noticed that there is no wear on the back side of the cam lobes...
The rockers are toast!
The only mods are: drilled larger oil passages to help oiling. And a cometic copper gasket.
I don't use a valve cover gasket, just hondabond. Though i was careful not to use too much, to avoid clogging any passages.
The lack of wear is bugging me.
ANY thoughts??
My most recent fubar, i noticed that there is no wear on the back side of the cam lobes...
The rockers are toast!
The only mods are: drilled larger oil passages to help oiling. And a cometic copper gasket.
I don't use a valve cover gasket, just hondabond. Though i was careful not to use too much, to avoid clogging any passages.
The lack of wear is bugging me.
ANY thoughts??