DCC seat that allows for stock wheel travel?

huck_finn

Been Around the Block
Does anyone know if any of the seats that DCC has on their site would allow me to keep the stock rear wheel hump (?) on my '74 360?

My original plans were to create a brat - but I am beginning to pivot on the idea just because I don't want my rear wheel to come crashing into my backside.
 
I dont have a 360 but on a 75 CB550 the Thruxton pan is as good as it gets to fitting for a universal seat pan. The stock inner fender will be in the way slightly so a little persuasion is needed but the rest of it is just about spot on. Again, this is on a CB550, not sure of the differences.
 
It really depends on what shocks you are running. If you get some slightly longer or with adjustable ride height, then you can go with a flat seat. Just know that it will effect handling.

but I kinda remember that there is no way that the rear tire would come close to the inner plastic panel on a CB360 at full compression on the rear. But if you run knobbies on your Brat, that can change.
 
Back
Top Bottom