I saw a tutorial online that said to adjust to 16mm, is that too low?crazypj said:I've done a load of 360 carbs, 6mm seems a lot to adjust but I have seen tem with very low float levels. Are you set at 19mm or 21mm?
I saw a tutorial online that said to adjust to 16mm, is that too low?crazypj said:I've done a load of 360 carbs, 6mm seems a lot to adjust but I have seen tem with very low float levels. Are you set at 19mm or 21mm?
irk miller said:You said the line had no fuel in it when you started, but it was full when you got back? That's normal. The float doesn't open until you start to drain it while running. If you have the lines off, or just installed them, then they'll stay empty until you use some fuel. If no fuel was going into the carb, then the tube would never fill up.
rsjudka said:I saw a tutorial online that said to adjust to 16mm, is that too low?
irk miller said:You said the line had no fuel in it when you started, but it was full when you got back?
rsjudka said:the left only had fuel on the carb side, and the right had fuel only on the pet cock side.
crazypj said:Did you do underneath tank with heat reflective tape?
crazypj said:I've been thinking of fitting a 'Tufnol' plate to the mounting plate to deflect some of the heat away from carbs. I have some about 1/16" thick sheet. The carb mounting plate has the ejection pin bosses that could easily be drilled at tapped 3mm~4mm.