Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
We noticed you are blocking ads. DO THE TON only works with community supporters. Most are active members of the site with small businesses. Please consider disabling your ad blocking tool and checking out the businesses that help keep our site up and free.
Its running super lean at idle. Won't go beneath 2k RPM and still backfiring through the airbox so its gotta still be leaking vacuum somewhere either in the carbs or the intake manifold.
There were some cracks inside the intake boot where the lip of the carb seats, but nothing on the outside. No used intake manifolds available and new is $127.
Ordered some of the self-fusing tape from Matt. Will wrap the intake boot up as well as I can and see how it fares. If it improves or fixes the issue I'll go ahead and order a new intake boot.
Also, don't forget, these carbs are unfortunately prone to have issues if the air box isn't in perfect condition. You can be lean because of the air box side, not just leaky intakes.
Been through there a few times. I am convinced I need to deal with the intake boot before moving on, as spraying starter fluid around the intake boot caused surging. That and the high idle condition lead me to believe it is an issue on the intake side rather than exhaust gaskets etc, most of which I have checked.
Nothing super exciting to report. I pulled the carbs completely apart for the 100th time and went through them with a super fine tooth comb. Threw the bodies in the ultrasonic cleaner, along with the brass. Replaced all 4 o-rings in each carb. I noticed that the PO had placed the plastic spacers on the needles above the circlip, rather than below (toward the slide body). So I reassembled those correctly. Set float heights to 14.6mm and set the mixture screws to the stock setting 3.5 turns out.
She’s running great after the thorough go-round with the carbs. I’m sure it was a combination of the incorrectly assembled needle spacers and crusty old o-rings.
Next up is to address the chatter in the clutch. I pulled the left side cover off again and removed the clutch assembly for inspection. I checked all the fiber discs and pressure plates on a flat surface, and everything looked great. They were pretty sticky as there was hardly any oil between a lot of the plates. It’s been a few years since this bike has moved under its own power so that’s not surprising.
I wiped everything down, generously oiled up all the discs and reassembled. Clutch springs all measured right where they should be. I need to grab the correct moly grease for the clutch activator rack & pinion, then I’ll slap everything back together and test it again.
I drained the oil before pulling the side cover, there was a tiny bit of residual crap in the bottom of the OIF tank from the leaky head gasket, but no more nasty chocolate milk oil!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.