crazypj
Split personality, I fake being smart
If those flanges are cast then machined, I probably wouldn't use them either, too much localised stress around mounting bolts in my opinion although spoke holes should be fine.
If they are 6061 T6, about 1/4" thick then hard anodised they will be MUCH stronger than the cast hubs 'everyone' used from 60's to 2000+ (and still use today)
7075 would be even stronger either will bend rather than crack. I would make my own if I was in the market for a par as I would then know exactly what has been done and the material.
Spoked wheels will need checking after 100 and 500 miles then will probably be fine for next 50,000 or more miles (in my experience of aluminium alloy rims)
MX and Enduro bikes are the only ones that can need wheel maintainance every week / month / ride( when 'used properly' )
If they are 6061 T6, about 1/4" thick then hard anodised they will be MUCH stronger than the cast hubs 'everyone' used from 60's to 2000+ (and still use today)
7075 would be even stronger either will bend rather than crack. I would make my own if I was in the market for a par as I would then know exactly what has been done and the material.
Spoked wheels will need checking after 100 and 500 miles then will probably be fine for next 50,000 or more miles (in my experience of aluminium alloy rims)
MX and Enduro bikes are the only ones that can need wheel maintainance every week / month / ride( when 'used properly' )