Hi Kev, yes a few have done it and it looks so much better. What I did was to trawl through the charity shops looking at the different belts as there are loads to choose from. Once you have your belt fasten it and then cut it opposite the buckle so that when laid out the buckle is in the middle, Remove seat then you can then decide whereabouts on the tank you want your buckle. to secure top end of belt cut a slot in it about half inch from end and secure with front STD mount. Then pull down the rear of the belt and make a hole where tank securing bolt holds tank on, re-fasten tank in place. To stop it chattering on paint I used double sided tape just to hold it in place. Re-fit seat and job done. Please note, you can't undo belt once in place, but there again there is no need to.