Custom Triple Trees - CB350/400/550/750/GL1000 - Other designs available
- Thread starter slikwilli420
- Start date
K
Kamn
Guest
Can you PM me what something like that top triple would cost??
slikwilli420
Been Around the Block
Bump.
Tune-A-Fish
BOTM LOSER Proudly Deplorable
You could build my rear motor mount for the CB so i can toss the 3 spacers I have now :-X
slikwilli420
Been Around the Block
What kind of motor mount design do you have in mind?
Tune-A-Fish
BOTM LOSER Proudly Deplorable
If you have a SOHC near by, I need to move the right side rear from inside to out, Honda already does this on later years but I want to match the one I made for the front, but this will require a small chunk of bilet maybe 3X4X1.25" because of the spacer to the motor... two piece would be fine but for now I'm using four :-\
This: is the rear with markings for the spacer measurements, the spacer in the image is for an exhaust used as an example
This: is the rear with markings for the spacer measurements, the spacer in the image is for an exhaust used as an example
Attachments
slikwilli420
Been Around the Block
Yeah I'm sure we could come up with something. All I do is Honda 750/4's so I should have the stuff to mock something up. PM me and we can talk more there.
slikwilli420
Been Around the Block
Bump.
Chuck78
Been Around the Block
Matt did a real nice job on making me a Rickman reproduction underslung AP Lockheed rear caliper mount just recently. I'm definitely wanting to have him make me a set of billet triples for the Rickman to run 89 GSXR1100K forks once I get my ride heights and rake and trail figured out...
slikwilli420
Been Around the Block
Bump.
