AzHonda
Coast to Coast
Hello all. I hope I started this thread in the right section.
I have a cb360 and have been restoring it. I am to the point where I bought some Clubmans in place of the stock bars. Here is my question. Since the clubmans do not allow for internal wiring and it looks like there is no way to get the wires to bypass out of the housing where the switches are located so that they can clamp down on the bars where they need to go (unless I cut a C-channel somehow to give space for the wires). Does this make sence?
Am I forced to go and buy after market switches where the wires can run externally?
My other thought is to drill a hole right where the mount would go and one more hole on the out side to bring the wires out. Would this ruin the integrity/strenght of the bars?
Options? Thoughts?
I have a cb360 and have been restoring it. I am to the point where I bought some Clubmans in place of the stock bars. Here is my question. Since the clubmans do not allow for internal wiring and it looks like there is no way to get the wires to bypass out of the housing where the switches are located so that they can clamp down on the bars where they need to go (unless I cut a C-channel somehow to give space for the wires). Does this make sence?
Am I forced to go and buy after market switches where the wires can run externally?
My other thought is to drill a hole right where the mount would go and one more hole on the out side to bring the wires out. Would this ruin the integrity/strenght of the bars?
Options? Thoughts?
