A CB360 Build - Lil' Sebastian Rides Again

[Sonreir]

New copper crush gaskets might help. As long as there are no exhaust leaks, I wouldn't worry too much about it, though.

[el barto]

New copper crush gaskets might help. As long as there are no exhaust leaks, I wouldn't worry too much about it, though.

I did the initial installation with new gaskets, will try again and see where I end up. Thanks

[advCo]

those flanges look right. The ones that came with Luna were mangled on the edges of the bend, like osmeone had tightened them down without making sure the headers were properly installed. I ended up buying a new set, they are pretty reasonable from the honda dealer and you can probably find them cheaper on ebay

[el barto]

Guys quick question - I didn't take photos of this and should have done originally and I apologise if it's a fuckin' stupid question: does the positive from the battery go in to the yellow/red terminal on the starter solenoid? Had everything apart and now can't remember which order it was in!

[crazypj]

No.
Red goes into fuse box, goes to ignition switch then comes out as a black wire.
Black goes into right side handlebar switch and comes out as red/yellow (if you have safety switches it's a little different but basically goes to left clutch switch first)

[el barto]

No.
Red goes into fuse box, goes to ignition switch then comes out as a black wire.
Black goes into right side handlebar switch and comes out as red/yellow (if you have safety switches it's a little different but basically goes to left clutch switch first)

Thanks PJ. My solenoid has the same layout as this (couldn't find anything in the shop manual):

[el barto]

Afternoon all. Received a new right hand control from 4into1 today, anyone have any experience with this particular unit? So far it isn't playing nice... http://4into1.com/reproduction-throttle-switch-assembly-35300-341-671-honda-cb550k-cb750k/

[Sonreir]

You know what the wire colors are for?

[el barto]

You know what the wire colors are for?

Yeah! It's the same layout as this from Common Motor:



I think the problem lies in the On/Off switch. I tried connecting the brown/white wire into the brown/blue of the harness (which looks to me like its corresponding wire) but no dice.

[Sonreir]

Try the black/yellow wire on the left control.