CB 350F Getting there...slowly !!

Mine sits high too and it really bothers me. I just used good old fashioned sand sand and sand again. I started with 220 and went up to 1000 grit, then rubbed it with mothers polish.
 
Yes I'm considering cutting out 1/2 inch section of each leg of the bracket and welding together, I may need help with this lol!

Ok thanks I need to get sanding then as looks incredible!
 
Been a while but still working ..I'm not good at keeping up with this thread..
 

Attachments

  • 20171125_210716.jpg
    20171125_210716.jpg
    1.1 MB · Views: 262
  • 2017-11-25 21.11.45.jpg
    2017-11-25 21.11.45.jpg
    1.8 MB · Views: 263
  • 20171125_211503.jpg
    20171125_211503.jpg
    302.9 KB · Views: 265
Thoughts on these side covers?
 

Attachments

  • 20171125_213123.jpg
    20171125_213123.jpg
    924.4 KB · Views: 282
  • 20171125_213229.jpg
    20171125_213229.jpg
    1.1 MB · Views: 266
Thinking about using something like this to hold the air filter... and make a fiberglass copy of the stock air box
 

Attachments

  • UPP-UMR-443_xl.jpg
    UPP-UMR-443_xl.jpg
    61 KB · Views: 267
Oh boy...December. Shame on me. Not much to report really. I got the petcock mounted and no leaks. Started on the seat finally.
 

Attachments

  • 20180425_202327.jpg
    20180425_202327.jpg
    818.2 KB · Views: 233
Back
Top Bottom