Cb 360 tail chop swinger mod

Ya I debated what to use for a while then finally found an old snow ski. Composite technology ;D .

Gotta say this concept kinda scares the hell out of me . But hey if it works it works. Can't wait to see more progress with it for sure! Good job man keep on it! ;D

skiing would be the scariest thing I have ever done with a ski under me.

i'm expecting this to end badly, but i admire the creativity

so has there been any progress i just found the thread and i like it would love to see what has happend

Well I bought the pod filters, new carb jets, plugs, points. I can get it to run great sitting in the shop but as soon as I try to ride it, its clear I don't have things dialed in. To be honest I haven't been able to sort out the problem (Timing vs carb, or ?) it often ends up running on one cylinder -but not usually the same one. It did all this same stuff before the jet kit but I assumed it was just running lean -though the plugs would foul at idle. Lately the weather has been great, and I do have a bike that runs fine, so I haven't spent more than a couple, hours a week, trying to figure it out.
Any input from someone who has sen this before would be appreciated.