I'm thinking of mounting a front fender on my rear wheel, in 'hugger' mode. As a means of mounting it, is this feasible? Strong enough?
Weld a plate on top of the axle adjuster to accept the four fender stays. Would like to mount little brake light/license plate holder to it as well (where the fork brace rivet holes are). This way if you adjust the chain length, the fender follows the wheel.
Weld a plate on top of the axle adjuster to accept the four fender stays. Would like to mount little brake light/license plate holder to it as well (where the fork brace rivet holes are). This way if you adjust the chain length, the fender follows the wheel.