FS: Unused Cone Muffler

nathanhouse

Active Member
Hello gentleman,
It's been a while since I've been on here since I sold the cafe cb450 project for my wife to her brother. You know the deal loving across country a couple times and also had my bike, which is now a project.... Anyway I have a muffler from Cone Engineering that I'm not going to be using. It's 18" long 2.25" inlet and same outlet. All stainless steel. If you would like to read more about the specs it's on their website. http://www.coneeng.com
The wire spring tabs and the place to mount a bracket has been welded on already. I've put the dimensions from their website below.
Very nice looking muffler, I just decided to use something else.

2.25" ID 2.25"x4.25"x15"L 4.25"x2.25"x3"L 18" OAL.
MS perforated core w/SS wool wrap.
Part number MC-2250-18-SS
(Their cost = $154.00)

$120 + shipping from N.H.









 
I'll have to check to see what it will cost. If not free I can probably get a good deal on shipping, let me check..
Where are you? Pm me an address.
 
Back
Top Bottom