NEEDED: copper washers for cylinder head bolts on a cb/cm 400T

alex2445

Been Around the Block
I need the little copper washers that go on my cylinder head bolts. The bike is a 1979 cm400T, but CB400t will work as well. I kinda lost some of them :( Or if anyone has any information on sourcing them or making my own. Thanks!
 
measure the ones you've still got, then try local nut and bolt shop, or plumbing supplies or ebay. you're prob best off replacing the lot anyway
 
You can probably get some at an auto parts store as well, i had to get some a few years ago for something and thats where i found mine


Sent from my iPhone using Tapatalk
 
Called crush washers. lots of bolt places will have them. If you know the Bolt size, http://www.vintagecb750.com/ has them for a lot of bikes. There is a lot of cross over as the bolt sizes are similar on a lot of bikes.
 
thanks, I'd never seen them before so I thought that they were just a honda thing. did not know that. I found some on amazon and ordered them. Thanks again.
 
Back
Top Bottom