JonathanHValencia
New Member
Hey folks,
I got a rear and front sprocket spacer on my CB750K to run a wider rim and tire from Cognito Moto. When I go to put the nuts on the, studs are too short after the spacer is on. Anybody ever encounter this? If so, what’s the remedy ?
Also, how flush does the hub have to be. Fitting my sprocket assembly into my hub with the dampers is a pain in the ass!
Thanks in advance!
I got a rear and front sprocket spacer on my CB750K to run a wider rim and tire from Cognito Moto. When I go to put the nuts on the, studs are too short after the spacer is on. Anybody ever encounter this? If so, what’s the remedy ?
Also, how flush does the hub have to be. Fitting my sprocket assembly into my hub with the dampers is a pain in the ass!
Thanks in advance!