So I thought I’d try to install the Morimoto led handlebar lights.
While I love the moto gadget gear I wasn’t prepared to sell my kidney just yet to purchase it.
So my plan was to drill out the plastic stopper in the bar end and insert a rubber Gromit then run the electrical wire through the bar end.
Unfortunately what I didn’t count on was the fact the plastic stopper was about half an inch thick
So I had to run with plan B, which was to install the electrical wires without the rubber.
I cut some string and ran it through the hole with the intention of using it to pull through the electrical wire. Being a little slow, I forgot to tie the other end off. So as I tied one end to the electrical wire i pulled the other end of the string back through the handle bar end.
That was the first time, as I attempted to pull the first one through the electrical wire slipped out of the string so I repeated the process until it was successfully through.
Then once I attempted to do the same with the right hand handlebar I realised the rubber tubing that was provided to wedge the handle bar end in was a larger external diameter
, I searched the garage only to find one that was too small.
After a quick trip to the auto shop the guys they gave me some hose on the house I was pretty stoked. Then I finally completed the instal
I hooked up some power to see how she looks came up alright
Sent from my iPhone using
DO THE TON