CB350 Left Crankcase

Hello I have a 69 honda cb350

Currently replaced gasket on left side crankcase cover and permatex cooper gasket maker on outer edge of crankcase before placing new gasket on in case any fine hairline gouges and such. This was done due to oil leaking out bottom.
Ran great for a few days now it's dripping oil once again I wouldn't mind but blowing on to back tire that ain't a fun ride

Any solutions to what it can be don't feel like ruling another gasket taking cover off again

Clean both surfaces, use Honda bond (or similar) and torque the cover bolts as per the factory specs.

That said, have you thoroughly inspected the cover and crank case? Are you 100% sure that there are no scrapes or gouges?

Inspected cleaned to a T Used permatex gasket maker
Torq value not listed on sheet I have

Tighten down Allen head bolts still leaking out the bottom one any solutions ?