oil filter cb360

cafebelan

Hollywood Cycles

• Feb 26, 2012

• #1

Sounds stupid but i cant get the oil filter off my 74 cb360.I removed the snapring and installed the 6mm bolt and pulled but no luck. Any suggestions.

 

crazypj

Split personality, I fake being smart

• Feb 26, 2012

• #2

First, try tapping cover in slightly and check for a burr on the groove.
Get a longer 6mm bolt and screw it in until it bottoms out, you can use it to push the outer piece off (crank end is solid, not drilled for oil feed)

 

cafebelan

Hollywood Cycles

• Feb 26, 2012

• #3

went out and tried again it came off,Idont think it has ever been off.There was alot of grime.THANKS PJ

 

cafebelan

Hollywood Cycles

• Feb 26, 2012

• #4

Anybody know of a place to get a clutch cover gasket,mine has a little piece out of it.

 

BriMed1983

Been Around the Block

• Feb 27, 2012

• #5

Try BikeBandit.com in the OEM section. fair price quick shipping. Or if you live in the GTA there is an awsome little shop called T.O cycle. They are off lakeshore rd just before you hit browns line. They actually stock alot of parts for older cb's I go there all the time.

 

VonYinzer

Over 10,000 Posts

• Feb 27, 2012

• #6

Autozone sells rolls of gasket material and razor blades... Save yourself some cash and DIY.