Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
We noticed you are blocking ads. DO THE TON only works with community supporters. Most are active members of the site with small businesses. Please consider disabling your ad blocking tool and checking out the businesses that help keep our site up and free.
OK, so I lied, it wasn't finished. The bike struggled to idle without the choke so I've installed larger pilot and main jets. One size up on the pilot, two sizes up on the main. I've also sealed the intake gasket with Locktite 5910 gasket sealant (think I had a small leak). I also realised that the pod I had fitted was possibly blocking the carb intake to the diaphragm so I've installed a 100mm x 54mm OD stainless steel tube inside a 100mm x 54mm ID rubber tube with a new larger oval pod on the end. Oh, and I also dropped the circlip on the needle jet one notch.
She is now purring like a kitten.
I'm also fitting a frame loop on the back end, then she will be truly finished.
Thanks SteveG, not started a thread yet but doing a lot of skip diving and this is where I am at the moment.
I am taking loads of photos, just need the time to put a thread together.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.