Guys,
We've taken on the entire Biltwell line. Fantastic stuff if you haven't seen it. http://www.biltwellinc.com
I've been looking around and have not been able to find 1" risers to fit the standard CB top trees so we're trying to determine what kind of interest there is from our demographic. Traditionally I know we run 7/8" bars but we're trying to think outside the box for our offerings as you guys know...
By going to 1" bars theres not only a host of other options out there but there's cool stuff like internal throttles and switch plates for the custom chopper market that we could begin to use on our metric builds. Not to mention that they just "feel" more substantial and commanding.
We're thinking if there is interest we mock up a set of hard mounted risers and ditch the rubber gasket idea for a strong, hard mounted surface and begin producing them.
What do you guys think? Opinons? Suggestions? Does something already exist that I'm missing?
Thanks!
J
We've taken on the entire Biltwell line. Fantastic stuff if you haven't seen it. http://www.biltwellinc.com
I've been looking around and have not been able to find 1" risers to fit the standard CB top trees so we're trying to determine what kind of interest there is from our demographic. Traditionally I know we run 7/8" bars but we're trying to think outside the box for our offerings as you guys know...
By going to 1" bars theres not only a host of other options out there but there's cool stuff like internal throttles and switch plates for the custom chopper market that we could begin to use on our metric builds. Not to mention that they just "feel" more substantial and commanding.
We're thinking if there is interest we mock up a set of hard mounted risers and ditch the rubber gasket idea for a strong, hard mounted surface and begin producing them.
What do you guys think? Opinons? Suggestions? Does something already exist that I'm missing?
Thanks!
J